SureAI

Hello all,

After some difficulty, I managed to install Enderal on a clean install of Skyrim on my PC on Steam. When I launch the game, I get the following error message quite a few times:

"The procedure entry point CreateDXGIFactory2 could not be located in the dynamic link library C:\WINDOWS\SYESTEM32\d3d11.dll"

If I just hit okay to get through the messages (probably about 15 of them), the game appears to boot normally. When I hit new, however, the only thing that renders is the skybox. None of the landscape, plants, or anything else. This is unfortunate.

I've checked and the file is where it says it should be, but something odd must be happening. Any known fix for this?

Thanks for any help,
Brian

welcome to the forum

sounds like this here

[+] in short

....so my fix was deleting (or better renaming) the dxgi.dll in my Skyrim folder...